Allied Telesis AT-S63 - Manual (Page 288)

Chapter 18: SNMPv3
288 Section III: SNMPv3
Displaying SNMPv3 Tables
This section contains procedures to display the SNMPv3 Tables. The
following procedures are provided:
ˆ “Displaying User Table Entries,” next
ˆ “Displaying View Table Entries” on page 290
ˆ “Displaying Access Table Entries” on page 291
ˆ “Displaying SecurityToGroup Table Entries” on page 292
ˆ “Displaying Notify Table Entries” on page 293
ˆ “Displaying Target Address Table Entries” on page 294
ˆ “Displaying Target Parameters Table Entries” on page 295
ˆ “Displaying SNMPv3 Community Table Entries” on page 296
Displaying User
Table Entries
To display entries in the SNMPv3 User Table, perform the following
procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 42.
2. From the Monitoring menu, select Mgmt. Protocols.
The Mgmt. Protocols page is displayed with the Server-based
Authentication tab displayed by default, as shown in Figure 13 on page
62.
3. Select the SNMP tab.