Allied Telesis AT-S63 - Manual (Page 285)

AT-S63 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 285
Note
The Row Status parameter is a read-only field in the web browser
interface. The Active value indicates the SNMPv3 Community Table
entry takes effect immediately.
10. Click Apply.
11. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Deleting an
SNMPv3
Community
Table Entry
To delete an entry in the SNMPv3 Community Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 89 on page 234.
3. In the SNMPv3 section, click the button next to Configure
Community Table and then click Configure at the bottom of the tab.
The SNMPv3 Community Table tab is shown in Figure 111 on page
283.
4. Click the button next to the SNMPv3 Community Table entry that you
want to delete and then click Remove.
A warning message is displayed.
5. Click OK.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Modifying an
SNMPv3
Community
Table Entry
To modify an entry in the SNMPv3 Community Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. Select the SNMP tab.