Allied Telesis AT-S63 - Manual (Page 321)

AT-S63 Management Software Web Browser Interface User’s Guide
Section IV: Spanning Tree Protocols 321
Note
If you do not want to change the active spanning tree protocol and
just want to enable or disable it, go to Step 5.
4. To change the active spanning tree protocol on the switch, click STP,
RSTP, or MSTP in the Active Protocol Version section of the tab. The
default is RSTP.
Note
Only one spanning tree protocol can be active on the switch at a
time.
5. To enable or disable the active spanning tree protocol on the switch,
click the Enable Spanning Tree check box. A check indicates that the
spanning tree is enabled while no check indicates that spanning tree is
disabled. The default is disabled.
6. Click Apply.
Note
If you changed the active spanning tree protocol, the switch resets
and your management session is ended. To continue managing the
switch, you must restart your management session after the switch
is finished reloading the AT-S63 management software.
7. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
8. If you activated STP, go to “Configuring STP” on page 304. If you
activated RSTP go to “Configuring RSTP” on page 312. If you
activated MSTP, go to “Configuring MSTP” on page 322.