Allied Telesis ALLIEDVIEW-UM 1.6 - Manual (Page 86)

Allied Telesis AlliedView-UM 1.6
User's Guide
PN 613-000381 Rev B
Page 86 of 129
Upload Parameters
1. Server - This is the address for the server that contains the GUI Resource file. If the server is a TFTP
server, the server address should be specified as an IP address. If the server is an HTTP server, the
server address should be specified as a URL.
2. Destination - This sets the location where the new GUI Resource file will be stored. This can be set to
FLASH or NVS.
3. Protocol - This specifies the protocol that the server supports. This can be set to HTTP or TFTP.
Device Selection
Before device selection can be performed, a GUI Resource file must be specified. After selecting a GUI
Resource file, the Available Devices list will be populated with the IP addresses of the devices to which
the specified GUI Resource file can be applied to.
Except for the above mentioned process, device selection is similar to that of the Release Upgrade
Operation pane.