Allied Telesis ALLIEDVIEW-UM 1.6 - Manual (Page 62)

Allied Telesis AlliedView-UM 1.6
User's Guide
PN 613-000381 Rev B
Page 62 of 129
Upload Parameters
1. Server - This is the address for the server that contains the Patch file. If the server is a TFTP server,
the server address should be specified as an IP address. If the server is an HTTP server, the server
address should be specified as a URL.
2. Destination - This sets the location where the new Patch file will be stored. This can be set to
FLASH or NVS.
3. Protocol - This specifies the protocol that the server supports. This can be set to HTTP or TFTP.
Device Selection
Before device selection can be performed, an patch file must be specified. After specifying a patch file,
the Available Devices list will be populated with the IP addresses of the devices to which the specified
patch file can be applied to.
Except for the above mentioned process, device selection is similar to that of the Release Upgrade
Operation pane.