Allied Telesis ALLIEDVIEW-UM 1.6 - Manual (Page 46)

Allied Telesis AlliedView-UM 1.6
User's Guide
PN 613-000381 Rev B
Page 46 of 129
Upload Parameters
1. Server - This is the address for the server that contains the release file. If the server is a TFTP server,
the server address should be specified as an IP address. If the server is an HTTP server, the server
address should be specified as a URL.
2. Destination - This sets the location where the new release file will be stored. This can be set to FLASH
or NVS.
3. Protocol - This specifies the protocol that the server supports. This can be set to HTTP or TFTP.
1. TFTP Server - This is the IP address of the TFTP server that contains the release file.
2. Destination Filename - This is a read-only field displays the name under which the software release file
is to be stored on the switch.
Device Selection
For devices that use AlliedWare™ management software, a license list file must be specified before
device selection can be performed. After selecting a license list file, the serial numbers contained within
will be checked against the serial numbers of the currently loaded devices. The IP Address of each
matching pair will be added to the Available Devices list.
For devices that use non-AlliedWare™ management software, a release filename must be specified.
After specifying the release file, the Available Devices list will be populated with the IP Addresses of the
device definitions that can use the specified software release file.
Device selection is performed as follows: