Allied Telesis ALLIEDVIEW-UM 1.6 - Manual (Page 54)

Allied Telesis AlliedView-UM 1.6
User's Guide
PN 613-000381 Rev B
Page 54 of 129
Upload Parameters
1. Server - This is the address for the server that contains the interim/maintenance release file. If the
server is a TFTP server, the server address should be specified as an IP address. If the server is an
HTTP server, the server address should be specified as a URL.
2. Destination - This sets the location where the new interim/maintenance release file will be stored.
This can be set to FLASH or NVS.
3. Protocol - This specifies the protocol that the server supports. This can be set to HTTP or TFTP.
Device Selection
Before device selection can be performed, an Interim/Maintenance Release File must be specified. After
selecting an Interim/Maintenance Release File, the Available Devices list will be populated with the IP
addresses of the devices to which the specified interim release file can be applied to.
Except for the above mentioned process, device selection is similar to that of the Release Upgrade
Operation pane.