Allied Telesis ALLIEDVIEW-UM 1.6 - Manual (Page 61)

Allied Telesis AlliedView-UM 1.6
User's Guide
PN 613-000381 Rev B
Page 61 of 129
9.1 CREATING A PATCH UPGRADE PROFILE
Software Selection
1. Patch Filename - Specify the Patch file to use.
2. Upload Options - Choose one of the following options:
ƒ Upload - Uploads the Patch file only.
ƒ Upload and set as temporary - Uploads, enables, and sets the Patch file as the temporary Patch
file.
ƒ Upload and set as preferred - Uploads, enables and sets the Patch file as the preferred Patch
file.
3. File Deletion Options
ƒ Delete old patch files if memory space is insufficient checkbox - If the devices to be
upgraded have limited memory space (e.g. routers), there might be a need to delete the existing
patch files in order to accommodate the new patch file. If a patch file cannot be downloaded due to
space limitations and this option is checked, AlliedView-UM will delete any patch files residing in the
device except for the currently installed patch. If unchecked, and there is not enough space to
accommodate the new patch file, AlliedView-UM will fail the operation.
ƒ Delete currently installed patch file if memory space is insufficient checkbox - This
option will only be enabled if the above option is checked. Otherwise, it will be grayed out. When
this option is checked, AlliedView-UM will also delete the currently installed patch file if there is still
insufficient space in the device after deleting the other patch files.
ƒ Reboot device after updating checkbox - If "Upload and set as temporary" or "Upload and set
as preferred" is chosen for the Upload Option, this checkbox will be enabled. When checked,
AlliedView-UM will reboot the device after a performing the software upgrade.