Figure 11: installing the media converter module, Chapter 2: installation 50 – Allied Telesis AT-MCF2012LC/1 User Manual
Page 50

Chapter 2: Installation
50
5.
Align the edges of the module with the guides in the
slot and carefully slide the module into the chassis until
it is flush with the front of the chassis. Refer to Figure
11. Light pressure may be necessary to firmly seat the
module connector on the connector on the back panel
of the chassis.
Caution
Do not force the module into place. Doing so may
damage the connector pins on the backplane of the
chassis. If there is resistance, remove the module and
reinsert it after verifying that the edges of the card are
properly aligned with the guides in the chassis’
module slot.
Figure 11. Installing the Media Converter Module
1
AT-M
CF
200
0
1121-a
A
T
-MCF2012LC
This manual is related to the following products: