Allied Telesis AT-MCF2000 - Manual (Page 29)

AT-MCF2000 Multi-channel Media Converter Chassis Installation Guide
29
3. Remove the AT-MCF2KPNL2 blank panel from one of
the power supply/fan module slots on the back panel of
the chassis by loosening the two captive screws on the
panel with a cross-head screwdriver. Refer to Figure 8.
The power supply module can be installed in either
power supply/fan module slot.
Figure 8. Removing the Blank Panel from a Power Supply/
Fan Module Slot
4. Slide the module into the slot as shown in Figure 9,
until it is flush with the back panel of the chassis.
You may need to exert light pressure to seat the
module in the connector on the back panel of the
chassis.
Caution
Do not force the module into place. Doing so may
damage the connector pins on the backplane inside
the chassis.
AT-MCF2KPN
L2 AT-MCF2KPN
L3
1111-a
MA
A