Allied Telesis AT-WNU300N - Manual (Page 28)

28 AT-WNU300N - IEEE802.11b/g/n 2T2R Wireless Fast USB Adapter - User Manual
2. In AT-WNU300N Wireless Utility, go to “WPS”. Click on “Rescan” to get the WPS signal from the
wireless AP.
Figure 42: Push Button Connection
3. Select the wireless AP from WPS AP List, and then click on “PBC” to implement the connection.
As the connection successes, the network will be shown in the WPS Profile list.
Figure 43: WPS Successfully
Note: After pushing PBC in wireless AP utility, you need to push “PBC” button on wireless
adapter in 120 seconds. Otherwise you need to perform the procedure from step 1.
Enter Wireless AP PIN code
1. In wireless AP utility, select generate PIN code and record the 8-character code. Then click on run
WPS.
2. In AT-WNU300N Wireless Utility, go to “WPS”. Switch the Config Mode to “Registrar”. Then input
the 8-character PIN code.
Note: The interface and terminology of wireless AP might be dissimilar in different models.
Please refer to their manuals for the configuration.