Allied Telesis AT-x510DP-52GTX - Manual (Page 67)

x510DP-52GTX Installation Guide
67
Connecting AC Power to a Power Supply Module
To power on a switch with one or two AC Power Supply Modules, perform
the following procedure:
1. Position the power cord retaining clip in the up position, as shown in
Figure 30.
Figure 30. Power Cord Retaining Clip in the Up Position
2. Plug the power cord into the AC power connector on the rear panel of
the unit, as shown in Figure 31. Lower the power cord retaining clip to
secure the power cord to the unit.
Figure 31. Connecting the AC Power Cord
Warning: Power cord is used as a disconnection device. To de-
energize equipment, disconnect the power cord.
E3
100-240V
AC ~
100-240V
AC ~