Allied Telesis AT-x510DP-52GTX - Manual (Page 62)

Chapter 4: Installing the Switch and its Power Supplies
62
5. If you are going to operate the switch with a single power supply
module, install the supplied blank panel over the second power supply
module bay, as shown in the following figure. This is necessary for
correct airflow.
Figure 24. Installing the Blank Panel on the Power Supply Slot
6. If you are installing an AC power supply module, see “Connecting AC
Power to a Power Supply Module” on page 67 for the power cord
installation.
7. If you are installing a DC power supply module, see “Power Wiring to a
DC AT-PWR250R-80 Power Supply Module” on page 69 for the DC
power wiring installation.
DC OUT
FAUL T A
T -PWR100R
100-240 VAC~ 2 A MA X