Allied Telesis AT-x510DP-52GTX - Manual (Page 115)

x510DP-52GTX Installation Guide
115
6. Verify the position of the handle on the SFP transceiver. If the
transceiver is in a top slot, the handle should be in the upright position,
as shown in Figure 72 on page 115. If the transceiver is in a bottom
slot, the handle should be in the down position.
Figure 72. Positioning the SFP or SFP+ Handle in the Upright Position
7. Connect the fiber optic cable to the transceiver, as shown in Figure 73.
The connector on the cable should fit snugly into the port, and the tab
should lock the connector into place.
Figure 73. Connecting a Fiber Optic Cable to an SFP or SFP+ Transceiver
8. Repeat this procedure to install additional transceivers.
S2/2
8
S1 /27
26
25
CON
SO
LE
SFP+
2678
SFP Handle
S2/2
8
S1 /27
26
25
CON
SO
LE
SFP+
2679