Allied Telesis AT-x510DP-52GTX - Manual (Page 17)

x510DP-52GTX Installation Guide
17
Power Supply
Modules
The AT-x510DP-52GTX switch has two rear slots for hot-swappable
power supplies. Power supply options are:
ˆ For AC power with back-to-front air flow, one or two AT-PWR100R
power supplies
ˆ For AC power with front-to-back air flow, one or two AT-PWR250
power supplies
ˆ For DC power with back-to-front air flow, one or two
AT-PWR250R-80 power supplies
Stacking Slots Two SFP+ slots can be used with special stacking transceivers to create a
VCStack of up to four switches that operate as a virtual switch. Here are
the basic features of the stacking slots on the AT-x510DP-52GTX switch:
ˆ Two stacking ports per switch
ˆ 40Gbps stacking bandwidth
LEDs
Here are the port LEDs:
ˆ Duplex mode and link/activity LEDs for the twisted pair ports
ˆ Link/activity LEDs for the SFP+ slots
ˆ Stack ID number LED
ˆ eco-friendly button turns off the LEDs to conserve electricity
Installation
Options
Here are the installation options for the switches:
ˆ 19-inch equipment rack - horizontal or vertical mounting
ˆ Desk or tabletop
MAC Address
Table
Here are the basic features of the MAC address tables of the switches:
ˆ Storage capacity of 16,000 dynamic MAC address entries
ˆ Storage capacity of 256 static MAC address entries
ˆ Automatic learning and aging
Management
Software and
Interfaces
Here are the management software and interfaces:
ˆ AlliedWare Plus Management Software
ˆ Command line interface
ˆ Web browser interface
Management
Methods
Here are the methods for managing the switches:
ˆ Local management through the Console port
ˆ Remote Telnet and Secure Shell management
ˆ Remote HTTP and HTTPS web browser management
ˆ SNMPv1, v2c, and v3