Samsung SWD-M100ZKECLW - Manual (Page 112)

109
Note: If the Mobile WiMAX USB connection mode was not enabled (step1),
the Network adapter reads: Windows Mobile-based Device.
Connecting to the Web via mWiMAX Connection Manager
Once your Connection Manager software has been properly
installed (page 107) and you have confirmed your device is
running CL24 software (or higher) (page 104), you are now ready
to begin your connection.
1. Activate the onboard WiMAX modem by navigating to the
WiMAX CM page and touching Connect:
• From the Today screen, touch WiMAX CM (left softkey).
• From the Today screen, touch Start ( ) > WiMAX CM.
Note: You must already have an active account with your service provider.
You must also have registered your device with this same carrier prior
to use of the mWiMAX Connection Manger application.
For more information, refer to “Connecting to a Mobile WiMAX
Network” on page 45.
2. Enable the PAM mode by enabling the External Connections
menu to enable Mobile WiMAX communication via the USB:
• From the Today screen, touch Start ( ) > Settings.
• Tap the Connection tab and touch External Connection > Mobile
WiMAX.
• Touch to save the new connection type and activate the
Samsung USB mWiMAX Adapter driver.
• The icon appears at the top of the screen when the PAM
feature is activated.
Note: To use the USB connection for data access to the device and microSD
card, activate the USB > ActiveSync feature.
WiMAX Adapter
ok
SWD-M100.book Page 109 Friday, March 5, 2010 5:49 PM