Aalborg TIO Totalizer I/O Flow Monitor/Controller - Manual (Page 27)

23
TABLE 5.1 SUPPORTED ENGINEERING UNITS LIST
NUMBER
FLOW RATE
ENGINEERING
UNITS
TOTALIZER
ENGINEERING
UNITS
DESCRIPTION
1 %FS %s Percent of full scale
2 ml/sec ml Milliliter per second
3 ml/min ml Milliliter per minute
4 ml/hr ml Milliliter per hour
5 ml/day ml Milliliter per day
6 litr/sec litr Liter per second
7 litr/ min litr Liter per minute
8 litr/hr litr Liter per hour
9 litr/day litr Liter per day
10 m^3/sec m^3 Cubic meter per second
11 m^3/ min m^3 Cubic meter per minute
12 m^3/hr m^3 Cubic meter per hour
13 m^3/day m^3 Cubic meter per day
14 f^3/sec f^3 Cubic feet per second
15 f^3/min f^3 Cubic feet per minute
16 f^3/hr f^3 Cubic feet per hour
17 f^3/day f^3 Cubic feet per day
18 gal/sec gal Gal per second
19 gal/min gal Gal per minute
20 gal/hr gal Gal per hour
21 gal/day gal Gal per day
22 gram/sec gram Grams per second
23 gram/min gram Grams per minute
24 gram/hr gram Grams per hour
25 gram/day gram Grams per day
26 kg/sec kg Kilograms per second
27 kg/min kg Kilograms per minute
The following selections are available: 1 second, 60 seconds (1 minute), 3600 sec-
onds (1 Hour), 86400 seconds (1 Day). The default entry is 60 seconds. If a mass-
based User-defined Unit is desired, the “UD Unit Use Density” parameter must be
set to “YES”. The default entry is “NO” so the Fluid STD Density parameter is not
used for flow rate calculation.