Videotec ULISSE MAXI - Manual (Page 26)

EN - English - I
nstruc
tions manual
24
7.4 Configuration
Before powering the device it must be configured
correctly by setting the dip-switches inside the
configuration window. Open the window by undoing
the screws as shown in the illustration:
Fig. 49
7.4.1 Dip-switch configuration
The following diagram represents the position of
the dip-switches when the configuration window is
opened.
j When the dip-switch rocker is up it
represents the value 1 (ON) while if it is
down it represents the value 0 (OFF). This
rule is valid for all dip-switches except for
in the section "7.4.6 Serial terminations/
connections", page 27 where they are
inverted.
Rocker up = ON = 1
Rocker down = OFF = 0
Rocker up = OFF = 0
Rocker down = ON = 1
Fig. 50
Baudrate Protocol Serial and Address
Termination of
RS485 lines
RS232 serial
connector
Fig. 51
7.3.3 Fastening of the wiper blade
Insert the blade in the wiper shaft.
Fig. 47
Position the blade in the stop position.
Fig. 48
h The correct adjustment must allow the
return of the blade to the stop position
going to the end stop on the casing’s plate.
Fasten the whole assembly by means of the washer
and nut.