Outback Power Systems GS4048A Operators Manual - Manual (Page 9)

Introduction
900-0161-01-00 Rev A 7
Inverter Functions
 Battery-to-AC inverting which delivers power to run backup loads and other functions
∼ Provides split-phase output
∼ Adjustable range of output voltage
∼ Settable nominal output frequency
 AC-to-battery charging (OutBack systems are battery-based)
∼ Accepts a wide variety of AC sources
∼ Requires split-phase input
 Uses battery energy stored from renewable resources
∼ Can utilize stored energy from many sources (PV arrays, wind turbines, etc.)
∼ OutBack FLEXmax charge controllers will optimize PV power production as part of a Grid/Hybrid system
 Dual AC inputs allow direct connection to utility grid and AC generator
 Rapid transfer between AC source and inverter output with minimal delay time
 Uses MATE3 System Display and Controller (sold separately) for user settings as part of a Grid/Hybrid system
 Stackable in parallel configuration up to ten inverters
 Certified by ETL to UL1741, CSA C22.2, and IEC 62109-1
 Field-upgradeable firmware
 Seven selectable input modes for different applications
∼ Generator
∼ Support
∼ Grid Tied
∼ UPS
∼ Backup
∼ Mini Grid
∼ Grid Zero
GS8048A
 8000 watts (8 kW) continuous power at 48 Vdc
 16.97 kVA peak surge capacity
 Modular internal design allows low idle consumption, high efficiency at both high and low power operation
GS4048A
 4000 watts (4 kW) continuous power at 48 Vdc
 8.48 kVA peak surge capacity
IMPORTANT:
The Radian inverter is not intended for use with the OutBack MATE or MATE2 System
Display and Controller. It is only compatible with the MATE3 system display.
NOTE: This product has a settable AC output range. In this book, many references to the output refer
to the entire range. However, some references are made to 120/240 Vac or 60 Hz output. These are
intended as examples only.