Outback Power Systems GS4048A Operators Manual - Manual (Page 10)

Introduction
8 900-0161-01-00 Rev A
Inverter Controls
The Radian inverter has no external controls. It can operate normally without an external control or
interface. Basic modes and settings are pre-programmed at the factory. (See page 65 for default
settings.) However, certain external devices can be used to operate or program the Radian.
On/Off Switch
The inverter can be equipped with a switch to turn it on and off. This switch is not sold as an inverter
accessory; a common toggle switch can be used. It is wired to the
Switch INV auxiliary terminals.
(See the Radian Series Inverter/Charger Installation Manual for more information on wiring the switch.)
This switch controls the inverting function only; it does not control the charger or any other function.
MATE3 System Display and Controller
The Radian inverter has no display or LED indicators. It is not possible to monitor its status or
operating mode without a metering device. The MATE3 System Display and Controller (sold
separately) is designed to accommodate programming and monitoring of a Grid/Hybrid power
system. The MATE3 provides the means to adjust the factory default settings to correctly match the
installation where needed. It provides the means to monitor system performance and troubleshoot
fault or shutdown conditions. It also has data logging and interface functions using the Internet.
Once settings are modified using a MATE3, the MATE3 can be removed from the installation. The
settings are stored in the nonvolatile memory of the Radian inverter. However, it is highly
recommended to include a MATE3 as part of the system. This provides the means to monitor system
performance and respond quickly should it be necessary to correct a fault or shutdown condition.
The MATE3’s Configuration Wizard is capable of automatically configuring inverters to a series of
preset values. This is often more efficient than attempting to manually program each setting in each
inverter. Affected fields include system type, battery charging, and AC source configuration.
NOTE: Radian models GS8048A and GS4048A can only be used with MATE3 firmware revision
002.017.xxx or higher.
IMPORTANT:
Some functions are not based in the inverter, but are part of the MATE3 system
display’s firmware. They will not function if the system display is removed.
These functions are listed beginning on page 45.
Figure 2 MATE3 System Display and Controller