DAVIS DriveRight 600E Users Guide (8126, 8179) - Manual (Page 21)

17
Settings Screens
• Set or Change the Security Code — Use PLUS and MINUS to
enter the current correct code, if entering the security code for the
first time, make sure 0000 is entered. Press and hold SET/
CLEAR until “CHG” (change) displays.
CODE
SETTINGS
Change Security Code
Use PLUS and MINUS to enter the new desired security code and
make a note of the new security code. When finished, press MODE
to save the new code and move to the Clear Log Screen.
Clear Log Screen
The Clear Log Screen may be used to perform a “total clear” function
which erases all data for every trip in your log at once.
Note: All the stored trips for every driver are cleared using this screen.
CLEAR LOG
SETTINGS
Clear Log Screen
Note: Accident and tamper log data cannot be cleared using this screen.
The following option is available in the Clear Log Screen:
• Clear all Log Data — Press and hold SET/CLEAR. The word
“CLR” (clear) appears in the display to indicate that the DriveRight
600
E
is preparing to clear all log data. To protect against accidental
clearing of data, press and hold SET/CLEAR for 3 seconds to clear
the data.