DAVIS DriveRight 600E Users Guide (8126, 8179) - Manual (Page 12)

8
Data Screens
5. When finished driving, compare the vehicle’s distance reading to the
distance reading on the DriveRight 600
E
.
6. Increase or decrease the distance measured by the DriveRight 600
E
until it agrees with the vehicle’s odometer reading. This is accom-
plished from the Calibration Screen.
7. Press and hold MODE to access the Settings Screens.
8. Press and release MODE until the Calibration Screen displays.
The distance traveled appears at the lower left of the display. Note that
until the DriveRight 600
E
is calibrated, this distance reading is inaccu-
rate. The speed reading and calibration speed, which appear on the dis-
play as well, are not necessary for this calibration process.
km/h
MPH SPEED
DISTANCE
MILES
K
m
SETTINGS
Speed Reading
Distance Reading Calibration Speed
Calibration Screen
9. Press PLUS or MINUS until the distance reading matches the distance
on the vehicle.
Note: Pressing and holding PLUS or MINUS increases the rate at which the DriveRight
600
E
adjusts the distance reading.
10. When finished calibrating, press and hold MODE until the Current
Readings Screen displays. All calibration information is automatically
saved.
Note: Do not press and hold SET/CLEAR in an effort to save the fine-tuned calibration. The
DriveRight 600
E
completely resets the calibration number if SET/CLEAR is pressed.
Data Screens
The following section explains all the information and options available in
the Data Screens. In addition to the options listed in the individual sections
below, the following two options are available in every screen:
• Move to the next Data Screen — Press and release MODE.
• View the Settings Screens — Press and hold MODE.