DAVIS DriveRight 130AL Manual (8140) - Manual (Page 9)

Page 7
Entering Settings
You should familiarize yourself with the procedure for entering settings into the
DriveRight 130AL, since you will need to utilize this procedure often when using
the unit.
NOTE: The instructions below demonstrate the settings entry procedure by showing
you how to set the time. The instructions assume that you have not yet entered a
code (see “Code Entry Screen” on page 18).
1. If necessary, press and hold MODE down to access the settings screens.
2. If necessary, press and release MODE until the set time screen appears.
You will be able to tell if a particular screen accepts data entry because one of the
digits or a display segment (for example, MPH or km/h) will be flashing. In this
case, the AM, PM, or 24HR segment will be flashing.
3. Press "+" or "-" to toggle between the PM, AM, and 24HR segments.
Each time you press "+" or "-" , the display segment changes. Changing the dis-
play segment changes the format in which the time appears (12 hour or 24
hour) and selects between AM and PM.
4. When the desired segment appears, press SET/CLEAR .
The display segment stops flashing and the first digit begins flashing.
5. Press "+" or "-" to increment the first digit.
Each time you press "+" or "-" , the digit increments one number up or down.
You may also hold "+" or "-" down to scroll quickly through available digits.
(Note that, for the first digit in the time, only 0, 1, and 2 are valid entries.)
NOTE: Make sure the time you enter is in the correct format (12 hour or 24 hour).
6. When the desired number appears, press SET/CLEAR .
The next digit begins flashing.
7. Repeat this procedure until all digits have been correctly set.
It makes no difference which digit you enter first. If you enter a digit incorrectly,
accidentally skip past a digit, or only want to change certain digits, simply press
and release
SET/CLEAR until the desired digit begins to flash.
8. When finished entering the time, press MODE .
This sets the time and moves you to the set date screen.
AM
SETTINGS
Flashing Segment