DAVIS DriveRight 130AL Manual (8140) - Manual (Page 13)

Page 11
7. If necessary, press and hold MODE down to access the settings screens.
8. If necessary, press and release MODE until the calibration screen
appears.
The distance travelled appears at the lower left of the display. Note that until
you calibrate the DriveRight 130AL this distance reading will be inaccurate.
The vehicle speed and calibration speed, which appear on the display as well, are
not necessary for this calibration procedure
9. Press "+" or "-" until the number of Miles or Km shown matches the
number of Miles or Km recorded by your vehicle.
Note that, depending on how many miles you drove, you may need to press "+"
or "-" more than once before you see a change in the distance register.
NOTE: Pressing and holding "+" or "-" down increases the rate at which the
DriveRight 130AL adjusts the distance reading.
10.When finished calibrating, press and hold MODE down until you
return to the current readings screen.
DO NOT PRESS AND HOLD SET/CLEAR in an effort to save the fine-
tuned calibration! If you press and hold SET/CLEAR, the unit completely
resets the calibration number. When you finish fine-tuning, press MODE to exit
the calibration screen. All information will be automatically saved.
U SING THE D ATA S CREENS
The sections below describe the components of each of the five data screens as well
as describing what DriveRight 130AL functions you may perform from each
screen. To switch to the next data screen, press MODE. To switch to the group of
settings screens, press and hold MODE down.
Current Readings Screen
The current readings screen displays the current speed and acceleration or decelera-
tion, distance travelled, and the time or date.
SPEED
CAL
MPH
DISTANCE
MILES
SETTINGS
Uncalibrated Distance Reading
PM
SPEED MPH
ACCEL
G
DISTANCE
MILES
CURRENT
Time/Date Current Speed
Current
Acceleration Total Distance
Travelled During Day