Use "+" and "-" to enter the correct code, After the code is entered correctly, press mode – DAVIS DriveRight 130AL Manual (8140) User Manual

Page 16

Page 14

• Show the time at which the maximum speed was recorded:

To display the time at which the maximum speed was recorded, press SET/
CLEAR

. The time appears in place of the date. To return to the date, press

SET/CLEAR

again.

• Erase an individual day from the log:

You may erase a day from the

log following the procedure below.

NOTE:

This procedure erases all data for the day, not just the data displayed on

the speed distance log screen.

1. From the speed/distance log screen, press

"+"

"-"

until the

desired day appears.

2. Press and hold down

SET/CLEAR

until the unit beeps and the

code entry screen appears.

You must enter the correct code in order to clear a day in the log. See
“Code Entry Screen” on page 18 for details on using and entering codes.

3. Use

"+"

and

"-"

to enter the correct code.

4. After the code is entered correctly, press

MODE

Once you press MODE (assuming the code is correct), the DriveRight
130AL clears the data for the displayed day and returns you to the speed/
distance log screen.

NOTE:

You may erase every day in the log at once from the clear all log data screen

(see “Clear All Log Data Screen” on page 19).

SPEED

MAXIMUM

km/h

OVER

TIME

SPEED

Min.

DISTANCE

LOG

Time Maximum
Speed Recorded

CODE

SETTINGS

Code Setting