DAVIS DriveRight 130AL Manual (8140) - Manual (Page 23)

Page 21
Limit Entry Screen
The limit entry screen allows you to set limits for speed, acceleration, and deceleration.
You may also change the unit of measure in which speed is displayed (MPH or km/h).
You may perform the following functions from the limit settings entry screen:
• Enter/Change a Limit: Press and release SET/CLEAR until one of the
digits in the desired register (Speed, Acceleration, Deceleration) is flashing.
Then use "+" and "-" to enter a new limit.
NOTE: Each register contains three digits, the first of which does not appear unless
your set speed limit is 100 or above or your set acceleration and decelera-
tion limit is 1.00 or above. The third digit will appear as you enter a new
limit. The maximum limit settings are as follows: Speed 255, Acceleration
and Deceleration 2.55.
The table below translates “G’s” into the number of seconds it takes for a car to
go from 0 to 60 MPH (0 to 100 km/h). Use this table to help you decide on an
appropriate acceleration or deceleration limit setting.
• Change the Unit of Measure for Speed: You may select either MPH
or km/h.
1. Press and release SET/CLEAR until the display segment (MPH or
km/h) is flashing.
2. Press "+" to switch from MPH to km/h or vice versa.
Each time you press "+", the unit toggles between MPH and km/h.
G’s
0 to 60 MPH
0 to 100 km/h
G’s
0 to 60 MPH
0 to 100 km/h
G’s
0 to 60 MPH
0 to 100 km/h
0.05 54.7 s 0.40 6.8 s 0.75 3.6 s
0.10 27.3 s 0.45 6.1 s 0.80 3.4 s
0.15 18.2 s 0.50 5.5 s 0.85 3.2 s
0.20 13.7 s 0.55 5.0 s 0.90 3.0 s
0.25 10.9 s 0.60 4.6 s 0.95 2.9 s
0.30 9.1 s 0.65 4.2 s 1.00 2.7 s
0.35 7.8 s 0.70 3.9 s
SPEED MPH
ACCEL
G G
DECEL
SETTINGS
Speed Limit
Deceleration
Limit Acceleration
Limit