DAVIS DriveRight 130AL Manual (8140) Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for DriveRight 130AL Manual (8140) DAVIS
Manuals 
| Recognized languages: | English |
|---|---|
| Pages: | 32 |
| Size: | 322 KB |
Show table of contents
Document Outline
- 130AL-UG.pdf
- Introduction
- Optional Accessories
- Using the Davis DriveRight 130AL
- The Data Screens
- The Settings Screens
- The Buttons
- Entering Settings
- 1. If necessary, press and hold MODE down to access the settings screens.
- 2. If necessary, press and release MODE until the set time screen appears.
- 3. Press "+" or "-" to toggle between the PM, AM, and 24HR segments.
- 4. When the desired segment appears, press SET/CLEAR.
- 5. Press "+" or "-" to increment the first digit.
- 6. When the desired number appears, press SET/CLEAR.
- 7. Repeat this procedure until all digits have been correctly set.
- 8. When finished entering the time, press MODE.
- Calibrating the DriveRight 130AL
- Calibration Using the Speedometer
- 1. If necessary, press and hold MODE down to access the settings screens.
- 2. If necessary, press and release MODE until the Calibration screen appears.
- 3. Drive the vehicle until you reach 25 MPH (40 km/h) and keep the vehicle steady at that speed.
- 4. Once the vehicle is moving at the calibration speed, press and hold SET/CLEAR down.
- 5. Continue to hold SET/CLEAR down until the unit beeps and the word dONE appears on the display.
- 6. Once the calibration is complete, drive the vehicle and compare the vehicle’s speedometer to t...
- 7. If necessary, “fine tune” the calibration by pressing "+" or "-".
- 8. Continue to Press "+" or "-" until the DriveRight agrees with your vehicle’s speedometer at a ...
- 9. When finished calibrating, press and hold MODE down until you return to the data screen.
- Calibration Using The Odometer
- 1. Obtain a rough calibration, using the speedometer as described in “Calibration Using the Speed...
- 2. After obtaining a rough calibration, reset your vehicle’s trip meter to zero or make a note of...
- 3. Make a note of the distance travelled reading displayed in the Current Readings screen.
- 4. Drive your vehicle for at least 20 miles (32 km).
- 5. When you finish driving, determine how many miles/kilometers the DriveRight recorded by subtra...
- 6. Compare your vehicle’s trip meter reading to the distance travelled reading on the DriveRight...
- 7. If necessary, press and hold MODE down to access the settings screens.
- 8. If necessary, press and release MODE until the calibration screen appears.
- 9. Press "+" or "-" until the number of Miles or Km shown matches the number of Miles or Km recor...
- 10. When finished calibrating, press and hold MODE down until you return to the current readings ...
- Calibration Using the Speedometer
- Using the Data Screens
- Settings Screens
- Last Correct Code Screen
- Code Entry Screen
- 1. From the code entry screen, use "+" and "-" to enter the correct code.
- 2. When the correct code is entered, press MODE.
- 1. From the code entry screen, use "+" and "-" to enter your current code.
- 2. When the correct code is entered, press and hold down SET/ CLEAR.
- 3. Use "+" and "-" to enter a new code.
- 4. When the new code is entered, press MODE.
- Clear All Log Data Screen
- Alarm On/Off Screen
- Limit Entry Screen
- Calibration Screen
- Set Time Screen
- Set Date Screen
- Set Year Screen
- Miscellaneous Information
- Troubleshooting Guide
- Technical Specifications
- Warranty & Repair Information