DAVIS Universal Anemometer Interface for Vantage Pro2 - Manual (Page 8)

8
Connect the ISS Cable to the Interface
1. Feed one end of the 4‐conductor ISS cable into the same grommet as the 6‐
conductor cable.
2. Plug it into the RJ jack labeled “OUT.”
3. Secure both cables inside with the cable clamp. Place the cable clamp over
both cables between the grommet and the receptacle. Secure the cable clamp
to the shelter by threading the provided #6 screw through the washer and
cable clamp and then screwing it into the cable clamp mount inside the hous‐
ing. (See illustration on page 7.)
4. Close the shelter, being careful not to pinch the solar panel cable.
Connect the ISS cable to the SIM
For a Vantage Pro2 ISS
This illustration shows the Sensor Interface Module, or “SIM”, inside the 
Vantage Pro2 transmitter shelter.
Foam
Insert
Sensor
Interface
Module
(SIM)
ISS
Cable
1. Open the Vantage Pro2 transmitter shelter.
2. Pull the foam insert out of the cable access port in between the cables and set
the foam aside.
3. Insert the ISS cable through the cable access port with the connector lever
down.
4. Firmly insert the end of the ISS cable into the connector labeled WIND. The
lever clicks into place.