DAVIS Universal Anemometer Interface for Vantage Pro2 - Manual (Page 12)

Product Numbers: 6336
©2010 Davis Instruments Corp. All rights reserved.
Information in this manual is subject to change without notice.
Davis Instruments Part Number: 07395.231
Universal Anemometer Interface Manual
Rev. A , March 15, 2010
This product complies with the essential protection requirements of the EC EMC Directive 2004/108/EC and Low Volt-
age Directive 2006/95/EC. Davis Instruments Quality Management System is ISO 9001 certified.
3465 Diablo Avenue, Hayward, CA 94545-2778 U.S.A.
510-732-9229 • Fax: 510-732-9188
E-mail: [email protected] • www.davisnet.com
®
FCC Part 15 Class B Registration Warning
This equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to pro‐
vide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interfer‐
ence to radio communications. However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encour‐
aged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved in writing by Davis Instruments
may void the userʹs authority to operate this equipment.