DAVIS Anemometer Transmitter Kit Installation - Manual (Page 6)

Page 6
The factory default transmitter ID is ‘1’. Looking at the table below, you can see
that means the DIP switches are in the OFF position when each transmitting
station leaves the factory, whether it is an ISS, an anemometer transmitter, or
another kind of station.
Since the ISS is included with every Wireless Vantage Pro, the console/receiver
is set to find the ISS on ‘1’.
Set the ID of your anemometer transmitter to its
own number.
Use a ballpoint pen or paper clip to toggle DIP switches #1, 2, and 3. The set-
tings for transmitter IDs 1 – 8 are shown in the table below:
Use this table to ensure that each wireless transmitting station in your system is
broadcasting on its own transmitter ID.
DIP S WITCHES IN T OP - RIGHT C ORNER OF SIM (I LLUSTRATION HAS BEEN ENLARGED FOR CLARITY )
ID C ODE S WITCH 1 S WITCH 2 S WITCH 3
#1 (default) off off off
#2 off off ON
#3 off ON off
#4 off ON ON
#5 ON off off
#6 ON off ON
#7 ON ON off
#8 ON ON ON
1 2 3 4
ON
Battery Holder
DIP Switches