DAVIS Rain Collector II for GroWeather, EnviroMonitor, Weather Monitor and Wizard - Manual (Page 9)

Maintaining the Rain Collector II
9
Maintaining the Rain Collector II
For greatest accuracy, you should thoroughly clean the Rain Collector II at least
once or twice a year.
1. Disconnect the rain collector cable from the junction box.
2. Separate the cone from the base.
3. Use warm soapy water and a soft cloth to clean pollen, dirt, and other debris
from the cone, cone screens, and bucket.
4. Use a pipe cleaner to clear the funnel hole in the cone and the drain screens in
the base. When all parts are clean, rinse with clear water.
5. Reattach the cone and replace the screen.
6. Reconnect the rain collector cable to the junction box.
Using the Rainfall Function
The instructions below explain how to display rainfall on the Weather Wizard III
and Weather Monitor II.
To Display Rainfall
1. To display rainfall, press RAIN. The rainfall and the word RAIN display.
Daily Rainfall
2. To display total rainfall, press RAIN again. The total rainfall and the words
RAIN and TOTAL appear on the display.
Total Rainfall
To Change the Unit of Measure
1. Press RAIN once or twice to select rain or total rain, as desired.
2. Press UNITS. The amount shown changes from inches to millimeters (or vice
versa) and the symbol in the display changes from IN to MM (or vice versa).
3. To return to the original unit of measure, press UNITS again.