Installing the rain collector ii, Typical weather monitor ii installation, Typical installation – DAVIS Rain Collector II for GroWeather, EnviroMonitor, Weather Monitor and Wizard User Manual
Page 6

Installing the Rain Collector II
6
If the rainfall amount displayed on the console increases by the expected
increment (either 0.01" or 0.2 mm) each time you tip the bucket, your rain
collector is working properly. If the display changes only after you tip the
bucket several times, the rain collector may be functioning correctly but you
may have an older version of the station console. See “Calibration of Older
Model Weather Stations” on page
10 for details.
Installing the Rain Collector II
Note: Climbing on your roof may be hazardous. If you are uneasy about installing your unit please have a qual-
ified professional complete the installation. Davis specifically disclaims any liability for injury or loss
resulting from the installation or use of the Rain Collector II.
Follow the instructions in this section to install your rain collector. Make sure you
read “Choosing a Location for the Rain Collector” on page
7 as it contains impor-
tant information concerning placement of the rain collector.
Typical Weather Monitor II Installation
The illustration below shows a typical rain collector installation for the Weather
Wizard III and Weather Monitor II.
Typical Installation