beautypg.com

To clear rainfall, Press clear and hold it down, Daily rainfall cleared – DAVIS Rain Collector II for GroWeather, EnviroMonitor, Weather Monitor and Wizard User Manual

Page 10: To set total rainfall, Press rain once or twice to select total rainfall, Calibration of older model weather stations, Standard setting, Metric setting

background image

Calibration of Older Model Weather Stations

10

To Clear Rainfall

Rain and total rain are independent of each other. You must clear each register
separately.
1. Press RAIN once or twice to select rain or total rain, as desired.
2. Press CLEAR and hold it down.

The display will flash several times and then the weather station clears rainfall.

Daily Rainfall Cleared

Note: Performing a “total clear” on the weather station does not clear rainfall.

To Set Total Rainfall

You may enter a total rainfall amount to represent any rainfall which accumu-
lated before you obtained the Rain Collector II:

1. Press RAIN once or twice to select total rainfall.
2. Use ENTER to set the total rainfall amount. See “Using the Enter Key” in the

weather station manual.

Calibration of Older Model Weather Stations

This information applies only to users of the Weather

Wizard II-S, Weather

Wizard

III, and Weather Monitor II manufactured prior to April, 1993. To check if

your station meets this criterion, press the RAIN button on the console. If, when
set to inches, the display reads 0.0 (rather than 0.00), you have an older model
station.

Standard Setting

When using the 0.01” setting of the Rain Collector II with an older model station,
note that the station is pre-calibrated for an earlier model 0.1" rain collector. To
re-calibrate your station, first set the display to inches, then change CAL to 0100.
(See “Rainfall Calibration Number” on page

4 and/or your station user’s manual

for instructions on how to change CAL.) Be aware that the console will revert to
its default calibration (i.e., 0.1") if it loses power.

Metric Setting

When using the 0.2 mm setting of the Rain Collector II with an older model sta-
tion, note that the station stores rainfall amounts in 0.2 mm increments but dis-
plays amounts rounded to the nearest whole millimeter.

Note: Keep in mind when testing the rain collector with older weather stations that the display adds 1 mm for

each 5 tips of the bucket. Because the display rounds, however, the first change occurs after the bucket
tips 3 times (0.6 mm rounded to 1 mm).