AMT Datasouth 4000 - Manual (Page 78)

User's Guide 78
After boot mode firmware is activated, the LCD will show the following.
Off line:
F/W Update Mode
The only possible actions at this point are to enter boot mode setup mode or cycle power to exit this
mode (after setting DIP SW 7 OFF). This setup mode works like normal setup mode except the feature
list is limited to specific features used during firmware updates. Press the FEED + PAUSE keys to enter
boot mode setup mode. The available features are described below:
FEATURE VALUES DESCRIPTION
Download New F/W N/A Press the CANCEL key to
start download mode. The
display will change to:
Download New F/W
Waiting For Data /
The printer will be waiting on
a firmware update file on
either the Parallel or Serial
ports. If needed, be sure to
configure the interface
features below prior to
starting the firmware
download. The utility
FlashWiz included on the
product CD is an excellent
tool for downloading firmware
files.
Reboot System N/A To exit boot mode and return
to normal PAL firmware
mode, press the Cancel key.
Ensure DIP SW 7 is off or
boot mode firmware will run
again. After a firmware
update is complete, this
feature is automatically
selected and allows the
printer to be rebooted with
the newly loaded firmware.
Interface Select Identical to feature in
standard setup mode.
COM1: Baud Rate Defaults to 57K baud when in
boot mode. Change to