AMT Datasouth 4000 - Manual (Page 35)

User's Guide 35
Setup Menu Operation
The standard feature settings are stored in non-volatile memory. These settings are detected and
applied at power up. After power up, any changes made to the standard feature settings will take
effect immediately. At power down the current standard feature settings are saved to non-
volatile memory. Any feature values modified by PAL
TM sequences are also retained on power
down unless the keypad is locked.
Setup Example
1) Press PAUSE to place printer Off Line.
2) Press FEED + PAUSE Simultaneously to enter Setup Mode.
3) Press and hold FEED then:
•
Press PAUSE to scroll up the list of features.
•
Press CANCEL to scroll down the list of features.
4) After the desired feature is selected, release the FEED key.
5) Press the CANCEL key to change from "Changing Feature Mode" to
"Changing Value Mode". The top line of the LCD should be blinking.
6) Press and hold the FEED key then:
•
Press PAUSE to scroll up or increase the value.
•
Press CANCEL to scroll down or decrease the value.
7) After the desired value is selected, release the FEED key.
8) Press the CANCEL key to store the selected value and change back to
"Changing Feature Mode". Top line should not be blinking.
9) Repeat starting with Step 3 for all features which need adjusting. When
finished press the PAUSE key to exit Setup Mode and return to On Line
state.
NOTE: Refer to the table on the next page for a list of features and values which
may be adjusted if needed.