AMT Datasouth 4000 - Manual (Page 22)

User's Guide 22
3. Rotate the green Print head Latch counterclockwise to open the print head.
4. Rotate the Side Access Door down to allow the media to be loaded under the print head
module.
Figure 15 - Print head Latch and Side Access Cover
5. Slide the Media Supply Guide to the full widest position.
6. Ensure the media is face out with the labels feeding from the top of the roll. If not obtain
correctly wound media from your supplier
7. Place the media roll on the Media Supply Spindle.
8. Slide the roll fully towards the center of the printer.
9. Slide the Media Supply Guide towards the center of the printer until it is snug against the
media.
10. Slide the green Outside Media Guide off the Front and Back Media Rails by pulling
straight out.
Figure 16 - Outside Media Guide
Back Media Rail
Front Media Rail
Outside Media Guide
Upper Media Sensor Arm
Lower Media Sensor Arm
Side Access Door
Print head Latch