JKS 7150 - Manual (Page 3)

JKS7150 JKS Adjustable Control Arm Installation Page 3
‰ 4. TIGHTEN MOUNTING HARDWARE
 Once both Adjustable Control Arms have been
properly installed, lower the vehicle to the ground
until coil springs are supporting the full weight of
vehicle.
 Using a torque wrench, tighten all mounting hard-
ware to 75 ft-lbs.
‰ 5. POST-INSTALLATION INSTRUCTIONS
 Adjustable Control Arms are supplied pre-lubri-
cated, although it will be necessary to add more
grease after they have been adjusted and installed
on the vehicle. Refer to Maintenance section for
specific lubrication instructions.
 Have vehicle professionally aligned before driving
on highway.
Maintenance
Control Arms should be greased regularly as part of ve-
hicle maintenance schedule. Lubricate using moisture re-
sistant marine style grease and a hand-pump grease gun.
DO NOT use a pneumatic grease gun. Add grease slowly
until resistance is felt. The internal spring-loaded seal can
be damaged by forcing too much grease into Control Arms.
©2013 JKS Manufacturing, Inc & Aftermarketing, LLC
Revision Date 10/30/2013