EOTech MTM Mini-Thermal Monocular - Manual (Page 39)

2-19
2.14 LASER POINTER
With the WTM powered on, pressing (and holding) the
LASER button activates the laser pointer until pressure is
released from the button. Continuous activation is
accomplished by double-tapping the LASER button. While
in continuous mode, pressing the LASER button again
(single-tapping) turns off the laser.
When the laser pointer is activated, a dot appears in the
center of the display reticle. Additionally, black and white
squares appear in the top right and bottom left corners of the
display as shown in Figure 2-11. Further indication that the
laser pointer is activated is provided by the green laser LED
shown in Figure 2-8.
Figure 2-11 Display with Laser Pointer Activated
|
― ▪ ―
|