EOTech MTM Mini-Thermal Monocular - Manual (Page 30)

2-10
2.4 ZEROING PROCEDURES – Continued
Table 2-1 Reticle Adjustments
Shot Group Movement
10 m 25 m 100 m 150 m 300 m
ZOOM 1X 1.2cm 3.1cm 12cm 18.5cm 36.9cm
ZOOM 2X 0.6cm 1.5cm 6cm 9.25cm 8.45cm
1. On a 25-meter zeroing target, mark the designated strike
point and designated strike zone using the target offset
values in Table 2-2.
2. Mount the target on an “E” silhouette or other suitable
surface at 25 meters.
3. Mount the WTM to the weapon.
4. Power up the WTM as described in section 2.7.
5. Align the WTM reticle with the center of the target per
section 2.16, RETICLE.
6. Fire a 3-round shot group and note the center of the shot
group relative to the designated strike point.
7. Adjust the position of the reticle to move the center of the
shot group to the designated strike point.
8. Fire another 3-round shot group and again observe the
center of the new shot group relative to the designated
strike point.
9. When 2 out of 3 rounds are in the designated strike zone,
the WTM / weapon combination is zeroed.