Ag Leader ParaDyme Auxiliary Harness Installation - Manual (Page 6)

6 ParaDyme System
Permanent Installation Procedure
10. Remove the dust cap or plug from the auxiliary connector under the GPS receiver. See Figure 5.
Figure 5 Remove Dust Cap
11. Connect the 12 pin connector from the Auxiliary Harness to the 12 pin connector located under the left side of the Roof
Module. Push until it clicks and locks in place. See Figure 6.
Note: Do not force the connection. If the connector does not engage easily, confirm that the orientation is correct. The
connector has two small key features that must be correctly aligned with two slots on the mating connector. To
remove, squeeze the two side latches on the connector and pull the connector away from the Roof Module Connector.
Figure 6 Power Connection
12. Connect your external device to the power connector (or one of the other connectors as needed).
13. Power up your ParaDyme system.