Ag Leader GPS 1000 Plus Operators Manual - Manual (Page 17)

GPS 1000 Plus Troubleshooting
Ag Leader Technology
14 December 2003 3000021
Troubleshooting The following is a list of problems that you may encounter with the GPS
1000 Plus and suggestions for troubleshooting. If you have a problem with
the system, please review the list before calling Ag Leader Technology.
If your troubleshooting does not solve the problem, please call Technical
Support at Ag Leader Technology (515-232-5363 ext. 1).
Problem Cause Solution
I lose "D" around
buildings when using
WAAS Differential
• WAAS signal isn't
being transmitted.
• The WAAS
satellite you are
using is being
blocked.
• Go to Raytheons website
(wwws.raytheontands.com/waas/)
and check the current status of
WAAS transmission.
• There are only two (2) WAAS
satellites that are low on the East
and West horizon. Building and
tree lines can easily block the
signal.
I'm connected to the
GPS 1000 Plus but am
not getting position
data.
• Bad Cable or
dirty/wet connector
pins
• The output settings
of the GPS have
changed.
• No Power
• The GPS 1000 Plus
is damaged.
• Check to make sure the cable isn't
damaged and that the connector is
clean and dry.
• Connect the GPS 1000 Plus to a
PC using the Aux. Power/Data
cable and run the GPS 1000 Plus
utilities program. Set the outputs
to what is required for your
operation.
• Verify that you are properly
connected to a power source.
• Call Ag Leader Technical
Support.