Ag Leader InSight Strip-Till - Manual (Page 9)

Part No. 2002831-42 Rev. C 9
Strip Till Control Settings
Product Density:
This density value (shown in
pounds per cubic foot, or lb./ft.3),
is stored with each combination of
product and control channel. Use
the keypad to edit, if needed. Note:
For proper machine performance
and accuracy, you should check the
Product Density daily.
CFR 1:
This setting represents the volume
of product distributed on the field
with each revolution of the
metering circuit. This is shown in
Cubic Feet per Revolution
(ft.3/rev).
Caution: New products will have a
default CFR number the first time
they are used. You must either
manually enter or perform a CFR
calibration routine for each product
once that product is created,
otherwise misapplication will
occur.
Static CFR Calibration: Press the
Static CFR Calibration button to
perform an automated routine to
calibrate each metering circuit.
This calibration is performed
before applying in field conditions.
In-Field CFR Calibration: Press
the In-Field CFR Calibration
button to perform an automated
routine to adjust the calibration
number for the selected metering
circuit. This calibration is
performed if there is a difference
between the amount of product as
logged as compared to what was
actually applied.