Ag Leader InSight Strip-Till - Manual (Page 3)

Part No. 2002831-42 Rev. C 3
Strip-Till Configuration (for multiple products)
19 Enter Container Capacity and Units
The Container Setup Wizard appears. Use the numeric keypad to enter the container
capacity and the drop-down menu, located underneath, to enter units. Press Next to
continue.
20 Select Container Name and Location
Use the keypad to enter a Container Name, and the drop-down menu underneath to enter
a Container Location.
21 Enter a Suggested Configuration Name
Use the keypad to enter a different name for the configuration (if desired), and press
Next. A suggested name has been provided, based on your previous selections. If this
name does not fully describe the configuration, you may change it here.
22 Add Equipment for a Multiple Product Application
The Operating Configuration Wizard reappears. Because we specified that we were
configuring a multiple product application in the first step of this procedure, we are now
asked to add more equipment to our configuration. Repeat steps 3-21. When you have
repeated these steps and have come back to the Add Equipment window, press the Next
button; then press Finish.
23 Select Ground Speed Source
Select your ground speed source. If you will be using GPS as the primary you will need
to select a secondary source.
Note: The Ground Speed Sensor must be calibrated for accurate speed and area
calculations, under the Vehicle Tab. Press Next to continue.
24 Enter Suggested Configuration Name
Use the keypad to enter a suggested name for your configuration. A suggested name has
been provided, based on your previous selections. If this name does not fully describe the
configuration, you may change it here. Press Finish when complete.