HP XP Racks - Manual (Page 132)

To do so, perform steps 10 to 26 in Migrating from HDLM Version 5.8.1 or
Earlier to Version 5.9 or Later on page 3-61 on the standby host.
5
.
Start PowerHA on the standby host.
When PowerHA starts, a warning message may be output, stating that
the custom disk method file (/usr/DynamicLinkManager/cluster/
dlm_hacmp_gdisk_check) does not exist. This message can be ignored
because it does not affect any operations.
The following is an example of such a message:
WARNING: Custom disk method: ghostdisks's file:
/usr/DynamicLinkManager/cluster/dlm_hacmp_gdisk_check does not
exist or is not executable on node: xxx
#
#
Name of the node being used.
6
.
Stop PowerHA on the active host.
Specify takeover as the shutdown mode.
7
.
Migrate HDLM on the active host.
To do so, perform steps 10 to 26 in
Migrating from HDLM Version 5.8.1 or
Earlier to Version 5.9 or Later on page 3-61 on the active host.
8
.
Start PowerHA on the active host.
When PowerHA starts, a warning message may be output, stating that
the custom disk method file (/usr/DynamicLinkManager/cluster/
dlm_hacmp_gdisk_check) does not exist. This message can be ignored
because it does not affect any operations.
The following is an example of such a message:
WARNING: Custom disk method: ghostdisks's file:
/usr/DynamicLinkManager/cluster/dlm_hacmp_gdisk_check does not
exist or is not executable on node: xxx
#
#
Name of the node being used.
If this warning message is output, proceed to step 9. If it is not output,
proceed to step 12.
9
.
While PowerHA is running, delete the custom disk method defined in 5.8.1
or earlier, or in 5.9 or later.
10
.
Add an HDLM custom disk method.
11
.
Synchronize the cluster resources.
12
.
Delete the custom disk method.
To do so, perform the procedure described in
Canceling Cluster Software
(PowerHA) Settings on page 3-110 on the active host.
13
.
Configure a custom disk method.
To do so, perform the procedure described in
Registering the HDLM Script
for PowerHA on page 3-95 on the active host.
14
.
If you deleted the disk heartbeat settings in step 2, re-configure the disk
heartbeats.
For details, see the PowerHA documentation.
3-66
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for AIX) User Guide