HP Optical Jukeboxes - Manual (Page 62)

3-24 Chapter 3
Operating the Jukebox
Changing SCSI IDs
CAUTION Do not turn power to STANDBY in this jukebox until you are sure the
SCSI bus is inactive. Removing power from a SCSI peripheral when the
bus is active can result in data loss and/or indeterminate bus states.
Check your host system manuals for information about checking the
SCSI bus status.
Changing an Optical Drive ID
Start with READY or SECURE in the display.
1. Press NEXT until SCSI ID * displays.
2. Press ENTER . AC ID * displays. (“AC” is the “jukebox controller.”)
3. Press NEXT until DRV 1 ID * or DRV 2 ID * (if your jukebox has two
drives) displays.
4. Press ENTER . DRV # ID? displays, where “#” is the number of the drive
you selected in step 3 and “?” is the ID to which your selected drive is
currently set.
5. Press NEXT until the ID you want displays.
6. Press ENTER . SET # (# is a number from 0-7) displays briefly and then
DRV # ID # displays again. The ID you chose is now set.
7. Press CANCEL two times to return to the READY state.
NOTE CONFLICT displays if you attempt to set the jukebox controller and a
drive to the same ID. Repeat the procedure and reset one of the IDs to
another, non-conflicting ID.
NOTE After you change an ID you may have to restart your host computer for
the new ID to be recognized.