HP Optical Jukeboxes - Manual (Page 14)

1-2 Chapter 1
Setting up the Jukebox
Setting Up the Jukebox
Setting Up the Jukebox
This chapter tells you how to connect the jukebox to your computer.
Follow the unpacking instructions printed on the outside of the shipping
carton before you complete the steps given in this chapter.
NOTE “Jukebox” and “library” are two, interchangeable terms used for this type
of data storage device. “Jukebox” is used in this document.
The term “autochanger” in this document refers only to the physical and
electronic components that manage the movement and storage of optical
cartridges inside the jukebox.
This chapter gives information on the following topics:
• choosing a proper environment for the jukebox
• identifying parts on the rear panel
• connecting the jukebox to your computer
• connecting power
• moving and shipping the jukebox
What you need for setting up the jukebox:
• power cord (included)
• SCSI terminator (included)
• 68-pin, high density SCSI cable of desired length
• single-ended or low-voltage differential SCSI host adapter with at
least two available addresses (at least three available addresses if you
are installing one jukebox with two drives).
• application software that supports this type of jukebox
• this guide (included)