HP Optical Jukeboxes - Manual (Page 50)

3-12 Chapter 3
Operating the Jukebox
Using the Front Panel Features
NOTE Don’t forget your security code. If you forget it, only your service
representative can reset the security code to the factory setting so you
can set a new code.
Start with READY or SECURE in the display.
1. Press NEXT until CONF * displays
2. Press ENTER . CONF 0 and a flashing 0 displays.
3. Press NEXT until CONF 17 displays.
NOTE Starting from when you press ENTER in the next step, you are prompted
to enter the current security code.
4. Press ENTER . CODE 1 and a flashing 0 displays.
5. Press NEXT until the first number of your current security code
displays.
6. Press ENTER . CODE 2 and a flashing 0 displays.
7. Press NEXT until the second number of your current security code
displays.
8. Press ENTER . CODE 3 and a flashing 0 displays.
9. Press NEXT until the third number of your current security code
displays.
10. Press ENTER .
NOTE If you entered an incorrect code, NO CONFIG displays briefly and then
CONF 17 displays. Repeat steps 4-10 again and enter the correct current
code.
After entering the current security code in the previous steps, you are
prompted to enter a new three-digit security code.
11. Press ENTER . NEW 1 and a flashing digit displays (the previous code
1).
12. Press NEXT until the first number you want in your security code
displays
13. Press ENTER . NEW 2 and a flashing digit displays (the previous code