HP ProLiant ML570 G4 Server - Manual (Page 71)

Hardware options installation 71
b. Install six 6-32 Torx T-15 screws (three per side) into the corresponding holes on the rack bezel.
8. Install the server into the rack (" Installing the server into the rack " on page 34 ).
Rack-to-tower conversion
The rack-to-tower conversion kit includes all equipment required to convert the rack model server into a
tower model server.
The rack-to-tower conversion kit includes:
• Tower bezel
• Casters (4)
• Tower bezel retention clips (2)
• Caster screws [8-32 Torx T-15 (12)]
• Tower cover screws [6-32 x 1/4 Torx T-15 (2)]
• Painted access panel
In addition to the items supplied in the conversion kit, use the Torx T-15 screwdriver (" Rear panel
components " on page 9 ).
Before proceeding with the rack-to-tower conversion:
1. Power down the server (on page 23 ).
2. Disconnect the power supply cables (" Redundant hot-plug power supply option " on page 62 ).
3. Disconnect all external cables from the server rear panel (" Rear panel components " on page 9 ).
4. Remove all cables from the cable management arm.
5. Remove all power supplies from the server (to decrease the weight) (" Redundant hot-plug power
supply option " on page 62 ).
6. Remove all hard drives from the server (to decrease the weight) (" Removing a hot-plug SAS hard
drive " on page 56 ).