Operations, Power up the server, Power down the server – HP ProLiant ML570 G4 Server User Manual
Page 23: Extend the server from the rack
Operations 23
Operations
In this section
Power up the server ................................................................................................................................ 23
Power down the server............................................................................................................................ 23
Extend the server from the rack ................................................................................................................ 23
Unlock and remove the tower bezel.......................................................................................................... 25
Remove the rack bezel............................................................................................................................ 26
Remove the access panel ........................................................................................................................ 27
Install the access panel ........................................................................................................................... 27
Power up the server
To power up the server, press the Power On/Standby button.
Power down the server
WARNING: To reduce the risk of personal injury, electric shock, or damage to the
equipment, remove the power cord to remove power from the server. The front panel
Power On/Standby button does not completely shut off system power. Portions of the
power supply and some internal circuitry remain active until AC power is removed.
IMPORTANT: If installing a hot-plug device, it is not necessary to power down the server.
1.
Back up the server data.
2.
Shut down the operating system as directed by the operating system documentation.
3.
If the server is installed in a rack, press the UID LED button on the front panel. Blue LEDs illuminate on
the front and rear panels of the server.
4.
Press the Power On/Standby button to place the server in standby mode. When the server activates
standby power mode, the system power LED changes to amber.
5.
If the server is installed in a rack, locate the server by identifying the illuminated rear UID LED button.
6.
Disconnect the power cords.
The system is now without power.
Extend the server from the rack
1.
Release the two levers on the lower outside corners of the rack.
NOTE: If the server is in a rack and in the shipping configuration, remove the two shipping screws directly
behind the levers.
IMPORTANT: If the server is installed in a telco rack, remove the server from the rack to access internal
components.