HP Pavilion t350.uk Desktop PC - Manual (Page 58)

50 user’s guide
The card reader is accessible on the front of the PC or located inside the front
cover of the PC. It has two or four horizontal card slots which accept the
memory cards and the microdrive disk drive.
Card 4-slot Reader 2-slot Reader
CompactFlash ™ type I media Lower left slot Upper slot
CompactFlash type II media Lower left slot Upper slot
IBM Microdrive disk drive Lower left slot Upper slot
Secure Digital (SD) Memory Card Upper right slot Lower slot
MultiMediaCard (MMC) Upper right slot Lower slot
Memory Stick ® (MS) Memory Card Lower right slot Lower slot
SmartMedia ™ (SM) Memory Card Upper left slot Lower slot
You can place media in one or more of the card slots and use each media
independently. Place only one piece of media in a slot at one time.
Each card slot has its own drive letter and icon. When you insert media, the
display label may change to the title of the media, if the title is present.
special note about the safely remove hardware utility
CAUTION: Do not click Stop in the Safely Remove Hardware
window with the USB Mass Storage Device selected. Doing so
removes the operating system recognition of the 7-In-1 memory
card reader from your PC; you must restart the PC to see your
memory card reader again.
If you open the Safely Remove Hardware window by mistake, click Close.
using the 7-in-1 memory card reader
NOTE: CompactFlash and Microdrive are keyed and cannot be inserted
incorrectly. Insert the receptacle edge (holes) of this media into the slot.
For the two-slot reader, the Secure Digital (SD) card, the MultiMediaCard
(MMC), and the Memory Stick (MS) card must be inserted upside down (gold
connector fingers facing up). Note the direction of the notched corner on the
media.
1 Insert the media into the card slot until it stops. The in-use light (A) on the
card reader lights, and the PC automatically detects the media.
2 The PC opens a window so you can use the media contents. You can copy
files from or to the media.
3 When you are done, right-click the drive icon, select Eject, check that the
in-use light is on but not blinking, and then remove the media. A steady light
indicates that the PC is not reading or writing the media.